Visit The Dirt Forum for More Information

Author Topic:   rear bumper cover
Whitelightning
Dirt Freak

Total posts: 429
posted December 27, 2004 08:22 PM  
How do yall mount the rear bumper cover that perfomance bodies has for 81-88 Monte SS. Will it go over a stock bumper or do you have to do it lile a nose peice and fabricate a bumper? Did you Cut of back of truck lid also? Thanks jus twanting to find the best way to do it,

BIGDADDYBOZ
Dirt Freak

Total posts: 466
posted December 27, 2004 09:50 PM  
When I did mine on a Monte I used the stock rear bumper and cut out the tail piece for the trunk because I didn't want to loose ant rear by cutting the trunk.

sjakes
Dirt Freak

Total posts: 254
posted December 28, 2004 05:53 AM  
Take a look at my site, I think I have a few on there that might help you. If not I can take a few and send them to you.

With me, I had to cut the **** out of the tail piece, per IMCA Rules. Trunk lid has to stay factory. All I did is trim a little at a time until the trunk sits inside the tail.

If you have any questions, send me an email, I'll try to help.

Shawn
sjakes@mn.rr.com

------------------
visit us at www.geocities.com/sjrracing


Racer0
Dirt Maniac

Total posts: 149
posted December 28, 2004 06:11 AM  
I fabricated a rear bumper and then just cut the trunk lid. Of course we don't have any rules about stock trunk lid or bumper.

speedy2
Dirt Full Roller

Total posts: 54
posted December 28, 2004 12:58 PM  

 
Heres a pic i got from istock59 i did the exact same way

robhbk24
Dirt Freak

Total posts: 372
posted December 28, 2004 02:48 PM  
mid 80s k car wagon aries/reliant rear bumper cover is a direct fit for a metric chassis.we ran them on our regals and montes with no problems at all they look like they came on the car. plus they are cheap.see atleast one good thing came from a k car

bobaluuu
Dirt Freak

Total posts: 474
posted December 29, 2004 06:05 PM  
Heck I just wanna know who was the guy who walked around to the back of a k car wagon and saw that it would fit. gotta be a fabricator

------------------
Light it up, Baby!

    

Back to the Archives