posted December 26, 2004 03:14 PM
whats the narrowest 9inch housing any of you all have found? Going to put it under ametric car. thanks
redneck racing Dirt Forum Champ
Total posts: 860
posted December 26, 2004 04:34 PM
Good question i would say 58in if you can find it but im really not sure. Eddie
Kent Dirt Maniac
Total posts: 102
posted December 26, 2004 05:06 PM
57.25" is the narrowest housing/rear end that Ford made according to my books. The Ford granada and Lincoln Versailles were two of the vehicles that had that rearend. You will need to check on the years that these particular reaends are applicable to for the narrow width. I would tell you but have my book borrowed out for now. StreetStock Chassis Technology by Steve Smith has all the info you need about this subject! Hope it helps!
Mikey14 Dirt Freak
Total posts: 265
posted December 27, 2004 10:31 AM
From flange to flange mine measures 56 inches and it came out of a 69 or 70's ford half ton.