Visit The Dirt Forum for More Information

Author Topic:   question Help
whitesracing
Dirt Maniac

Total posts: 121
posted October 04, 2004 05:47 PM  
ok guys i just got a 327 bored 60 with a steel crank it has 58 cc heads

ok my question what is the final cubic inch size i know 30 350 is a 355 but what is this one when i ran the numbers it says it could be a 67 302 -327-350
here is block numbers 3892657
crank number 2680
how will i know for sure what i got?

will i get an torque from this

using holly 4412 carb

any good ideas on a cam

any info would be great

[This message has been edited by whitesracing (edited October 04, 2004).]

[This message has been edited by whitesracing (edited October 05, 2004).]

rico 08
Dirt Forum Champ
Total posts: 1139
posted October 04, 2004 07:30 PM  
the only crank casting number i got(my book is 68' up only)is a 2690 casting for a 68-75 350 steel crank....check that number....the block is probably a 327,if all els fails just measure the pin height on the pistons or side by side compare them to a known 350 piston.

FlyNLoIMCA17
Dirt Forum Champ
Total posts: 753
posted October 04, 2004 07:33 PM  
Your bore will be 4.060" Yes you should be able to get good torque from it, depending on cam selection. Your best bet is call Competition Cams, tell them what you got what your doing with it and they will recommend the best cam for you.

iowatoolman
Dirt Freak

Total posts: 369
posted October 04, 2004 10:29 PM  
the 2680 casting is a small journal 327

as for a cam do you have any restrictions?
roller, lift,or vacuum???

i ran a 327 this year and kicked some ****
i ran a roller setup and was very happy with it but i had a vacuum rule to restrict my motor

drive hard or drive home

whitesracing
Dirt Maniac

Total posts: 121
posted October 05, 2004 05:15 AM  
yes i do have a rule , it cant be roller an has to pull 15 inch of vac at 900 rpms

the kind of track will be running is a semi bank 1/4 mile that goes dry slick at times
not real tacky only at beginning of day



    

Back to the Archives