posted September 03, 2004 07:55 AM
i have already started next years car and needed some advice on metric tricks i have piced up and how to apply them. i understand i can buy the top A arm mount how far back does it need to be? 6" ? and how do i remount the bottom ?
WesternAuto17 Dirt Forum Champ
Total posts: 569
posted September 07, 2004 07:21 AM
I don't believe you can move the lower mounts. But you bring up a good question. If you're allowed to move the upper A-arm mounts, where do you mount them?
Flanndad Dirt Freak
Total posts: 255
posted September 07, 2004 09:15 AM
On the bottom's you can oblong the hole to the outside, bolt it up with some big washer's on the outside. Pull the a-arm out from the car in position, then weld the washers to the mount's. Found this to be easy than moving the lower ball joint.