Visit The Dirt Forum for More Information

Author Topic:   metric upper tubular arms
GARYAL
Dirt Forum Racer

Total posts: 94
posted June 23, 2004 09:49 AM  
who makes a good upper control arms for the metric cars that will mount in stock location. i am going to run tubes but need it cheep as i can and still make it work i would also like to be able to use stock ball joints.

GARYAL
Dirt Forum Racer

Total posts: 94
posted June 23, 2004 01:46 PM  
still wandering

loojack
Dirt Maniac

Total posts: 196
posted June 23, 2004 02:38 PM  
Try Speedway Motors. Page 55 of their new catalog. IMCA approved, if that means anything, not cheap only $42.95 ea. Other than that try eBay or MR racing equipment at www.mrracingequipment.com. They sell used stuff, might be able to help....loojack

------------------
"loojackracing, a not for profit organization"

loojack
Dirt Maniac

Total posts: 196
posted June 23, 2004 02:42 PM  
Try the web site this way, www.mrracingequipment.com/ I think the period at the end is messing it up. Sorry..loojack

UFnARacing
Dirt Maniac

Total posts: 179
posted June 24, 2004 08:30 AM  
Something I've run into..........if you need a steel shaft, like I do, you can pretty much only get them for the screw in ball joints from most places. You can get some for the small bolt in ball joints from Howe.

------------------
http://webpages.charter.net/ufnaracing/

stockcar5
Dirt Forum Champ
Total posts: 578
posted June 24, 2004 10:49 AM  
the imca a arms are very weak. they are being redesigned right now. i think the new design will have steel cross shafts and tubes that are about twice as thick.

luke

------------------
www.geocities.com/dirtstockcar5

CLBaker25
Dirt Maniac

Total posts: 193
posted June 26, 2004 11:56 AM  
Wayne Larson Racing builds tubular A-arms that are similiar to the ones from speedway, but are considerably stronger.

340duster
Dirt Maniac

Total posts: 195
posted June 28, 2004 09:31 AM  
Try UBmachine, just installed a set on a metric car. You can get them with either screw in or stock ball joints.
http://www.ubmachine.com/index.html

    

Back to the Archives