Visit The Dirt Forum for More Information

Author Topic:   four link ?????????????????????????
joetaylor
Dirt Forum Champ
Total posts: 640
posted April 18, 2004 08:59 PM  
ok here it is I want to install a camero rear end in a metric car I want to use a 4 link the question has any body done this if so any pic would be great full reasion for the 4 link is I will not e able to weld the top ears onto cast iron so I would like to go with a 4 link thanks for any and all replies send pics to
joescchimke@aol.com

------------------
U LIFT U LOOSE

joetaylor
Dirt Forum Champ
Total posts: 640
posted April 19, 2004 03:10 PM  
I must be the first? well I guess I will let you know how it turns out

racer17j
Dirt Forum Champ
Total posts: 5390
posted April 19, 2004 07:19 PM  
what do you sugest then steel for the upper mounts? or cut the top mounts off an old metric? I'm a certified welder but not sure if weling the castiron is a good idea for racing

racer17j
Dirt Forum Champ
Total posts: 5390
posted April 19, 2004 11:28 PM  
the rear came out of a 76 camero with leafs

joetaylor
Dirt Forum Champ
Total posts: 640
posted April 20, 2004 08:40 PM  
the rear came out of a 76 camero with leafs

------------------
U LIFT U LOOSE

racer17j
Dirt Forum Champ
Total posts: 5390
posted April 20, 2004 09:14 PM  
the with is not the same I need 60" outside of flange the chevelle will not do it

------------------
U LIFT U LOOSE

ryan
Dirt Forum Champ
Total posts: 776
posted April 22, 2004 08:14 PM  
Take some 3/8ths and bend it into a channel and weld it to the outside of the pumpkin onto the tubes where it before it joins to the center so you are welding on steel. Then you can weld your ears onto the 3/8. We did that on a firebird rear a couple years ago. Can't you run a 9 inch?

    

Back to the Archives