Visit The Dirt Forum for More Information

Author Topic:   setup question
VMS Racer
Dirt Full Roller

Total posts: 59
posted April 09, 2004 05:32 PM  
Where running an 02 Monte carlo weighing in at around 3200. Its tight going in and loose coming out. Rear springs are 175 in right and 200 in left with 3 5/8 stagger. What can be done to stop this?

racerman707
Dirt Freak

Total posts: 374
posted April 09, 2004 06:57 PM  
Fix the tight going in first and will probably stop the loose off.Just a guess though not knowing anything about your cross,rear,left,springs,tires,etc.

juliaferrell
Dirt Freak

Total posts: 370
posted April 09, 2004 08:35 PM  
Your loose off because the car is flipping in the middle due to car working so hard to turn. If its loose in the gas then you should be throttling on entry. Working the car early for the corner. If the car goes left on the gas then you don't have a tight car??? If you give front rates and ride heights I'd be glad to help further.
Stagger can actually make you tighter coming off?? Are you running the same stagger up front?

jay116
Dirt Freak

Total posts: 428
posted April 09, 2004 08:42 PM  
reverse your rear springs and run the stagger no more than 1/2 inch , should take care of your problem

    

Back to the Archives