Visit The Dirt Forum for More Information

Author Topic:   how to set q-jet float
rogracer2
Dirt Maniac

Total posts: 119
posted July 28, 2005 05:05 PM  
How do you measure your float level with a Rochester 4 barrel carb? I've read you're supposed to take the top part of the carb off, tip it over, and measure the float - but exactly where do you measure it - at the end of the float, the middle, or where? Also, what is a good level to set the float at?

Any advice will be appreciated!

nine finger
Dirt Forum Racer

Total posts: 76
posted July 29, 2005 06:01 AM  
1/4 inch

8 fan
Dirt Roller

Total posts: 9
posted July 29, 2005 01:01 PM  
turning it upside down is for 2bbl. take the top off and remove gasket, then press down on inlet needle end of float until it is lightly seated, then measure about 1/8" back from end of float to the top of carb. set it at 1/4"

Back to the Archives