Visit The Dirt Forum for More Information

Author Topic:   SBC exhaust manifolds
Dirt Maniac

Total posts: 110
posted June 17, 2005 07:03 AM  
Last evening we saw a guy had some different looking exhaust manifolds on his car. Rules say "stock manifolds" and his passes tech. The manifolds look like the ends and middle portions are cast but there are tubes that run between the two, almost like a header. The car is top notch and I'm sure they used that stlye for a reason. It was on a mid 80's Monte. Any clue on these manifolds? Stock?

"Lift for a second, that's where you'll finish!"

Dirt Forum Racer

Total posts: 94
posted June 17, 2005 10:37 AM  
I've seen those manifolds, they come on 3/4 ton, 1 ton and bigger pickups, I had a 86 3/4 ton, they were on it, and my buddy had a 87 1 ton and they were on it also

Dirt Freak

Total posts: 265
posted June 28, 2005 10:18 AM  
Is this the ones?

kinda expensive new but atleast ya know what to look for in the salvage yard.

Dirt Freak

Total posts: 372
posted June 28, 2005 02:18 PM  
gotta get a set of them,sweet

Dirt Freak

Total posts: 265
posted June 29, 2005 11:45 AM  
anyone running these? I'd like to know how they clear on a metric frame with mid mounts.

Dirt Full Roller

Total posts: 28
posted July 26, 2005 05:53 PM  
Anyone ever thought of runin a manifold off of an lt1 they are cast they are stock and in an s10 350 interchange book they say they flow better than a short tube header. I have a set on my 305 2bbl the motor is basically stock with carb mods and it does just fine keeping up with the high dollar cheatn stock 305s at my local track

Dirt Forum Racer

Total posts: 92
posted July 26, 2005 08:04 PM  
1985 Chevrolet pick-up has those type of manifolds on it. They look like a combination of header and stock.

Back to the Archives