Visit The Dirt Forum for More Information

Author Topic:   MOTOR HELP
11chunk
Dirt Roller

Total posts: 12
posted November 06, 2004 07:00 PM  
Has anybody heard of useing connceting rods from a 300 6cyl ford in a sbc? Rules say we cant go over 360 c.i., 2 barrels,and no headers. We were going to used a set of power pac heads with flat tops. Want kind of cam would work best. We race on 1/4 mile banked track.

dirtracing76
Dirt Roller

Total posts: 19
posted November 06, 2004 10:01 PM  
what is a sbc not trying to knock u or nothing i really dont know

------------------
dirt is for racing asphalt is to get there

juni
Dirt Maniac

Total posts: 184
posted November 06, 2004 10:16 PM  
I read a article a few years ago on the 350 chevy should have built they used a 400 block 327 crank and 300 6 cylinder rods the pistons were custom built . If i recall they ran 11 or 12to 1 comp and ran it on pump gas for a street car it was in car craft mag I think . I was always currious how they could get away with that much compression on pump gas.

ruggs66
Dirt Maniac

Total posts: 193
posted November 07, 2004 09:04 AM  
Small Block Chevy.

good way to look for small block stuff on ebay also.... just type in sbc for a search...that will keep you busy for awhile.


racerman707
Dirt Freak

Total posts: 374
posted November 07, 2004 01:07 PM  
Inline engines have a centered beam on the big end of the rod where a v8,v6 has an offset beam. Put a centerd beam rod in an engine that needs to be offset and it'll knock the pistons and pins out. Not to mention a bent rod and rod bearing wearing on one side.

hibdonjr
Dirt Roller

Total posts: 21
posted November 09, 2004 05:21 PM  
Offset beam? Really? Never heard of it.

Back to the Archives