Visit The Dirt Forum for More Information

Author Topic:   TRANSMISSIONS
bfx racing
Dirt Full Roller

Total posts: 42
posted October 25, 2004 11:40 AM  
I'm talked out of my 200 r4 tranny.
I have a line on a 350 turbo
and a 400 turbo with a long tail stock... I'm thinking it wont fit with origional shaft(88 monte)any one know whay i would need to do?
or is a 350 turbo better?
thanks for all replies

------------------
If it aint got a motor...it's not a sport

gould
Dirt Forum Champ
Total posts: 730
posted October 25, 2004 06:04 PM  
how about a powerglide or a stick?

------------------
www.geocities.com/gouldracing11

ryan
Dirt Forum Champ
Total posts: 776
posted October 25, 2004 06:35 PM  
Out of the trannys you listed T-350 short shaft would be best. Couldn't tell you if the driveshaft would fit we run our motors setback from stock.

racer17j
Dirt Forum Champ
Total posts: 5390
posted October 25, 2004 07:23 PM  
we put a t400 in my brother-in-laws drag car 86 monte ss and i dont remember changing the yoke??? and i know we didn't have to cut the driveshaft
it was one built by TCI with a transbrake

drive hard or drive home

the t350 shortshaft fits right in too

bfx racing
Dirt Full Roller

Total posts: 42
posted October 26, 2004 08:44 AM  
Thanks all.... We can't use power glides and we have to leave the engine as original location...
I'm thinking the 350 for sure now...
thanks again!

------------------
If it aint got a motor...it's not a sport

Back to the Archives