posted November 29, 2003 10:04 PM
can i put a 5.42 gear in a 9" that had a 2.75 gear or is there a cut off ratio??
will i have to get another center section to go to the5.42??
martnracn_91 Dirt Maniac
Total posts: 113
posted November 30, 2003 12:03 AM
I beleive you can change any gear that you want to when it comes to nine inch as long as your splines dont change.
"CHECKER or WRECKER"
outlawstock17 Dirt Forum Champ
Total posts: 1363
posted November 30, 2003 06:13 AM
no problems changing gears in a 9". when you use a very low gear, you may have to grind a little on the housing near the inner most pinion bearing. sometimes the ring gear will hit it. other than that, you shouldn't have any problems.
[This message has been edited by outlawstock17 (edited November 30, 2003).]