Visit The Dirt Forum for More Information

Author Topic:   Mounting Seat Belts
Speed Racer X
Dirt Maniac

Total posts: 115
posted December 01, 2002 07:48 PM  
What is the safe set up to mount lap belts? From what I've read the lap belt shoud be mounted at a 45 degree angle to the drivers hips,at the same width as the drivers hips,and the belts should be kept as short as possible. Follwing these guidelines, in our car this would mean mounting the lap belt to the seat frame, this worries me. Our seat frame is 1 1/2 inch tubing welded to the roll cage and is very strong, but I would hate to find out it wasn't strong enough. Any suggestions??? Thanks.

racer17j
Dirt Forum Champ
Total posts: 5390
posted December 01, 2002 11:29 PM  
Your seat and belts should be mounted to the cage somehow and yes your seat can break loose and the belts will hold you in I use kicker bars off the cage and position my bracing so I can mount my belts on them this includes the crotch strap don't be foolish and shortcut on it's mount if you never want to need them but this is one area that overkill is not a bad thing

[This message has been edited by Flatlander (edited December 01, 2002).]

Eljojo
Dirt Forum Champ
Total posts: 968
posted December 02, 2002 05:38 PM  
Whenever your common sense is telling you not to mount a seatbelt tab to a part of the seat-loop, you really might want to listen. I've seen (and raced in) cars with the seat or the belts mounted to the floorpan. VERY BAD IDEA! Mount the belts to the main cage so that in the worst possible scenario, you will be held inside the rollcage! We've all seen horriffic crashes where the driver survived-virtualy unscathed that usually is the result of executing a safety plan using good equipment and good common sense. JMO

uforacing51
Dirt Forum Champ
Total posts: 570
posted December 03, 2002 11:50 PM  
You could also build another bracket that goes from doorbar to doorbar that is just for the belts. Your angles sound right, I bet steve smith auto sports has a book that would help you out too. good question and good luck.

Speed Racer X
Dirt Maniac

Total posts: 115
posted December 09, 2002 09:51 PM  
Thanks for all the help. We ended up running a 1 1/2 bar from doorbar to doorbar, just behind the seatframe. Then took 1/4 inch plate 2 1/2" X 6", (1 for each side of the seat)sawed a 1 1/2 hole in one end, slid it over the new bar, got the right angle then welded it solid, drilled a 1/2 hole for the lap belt to mount. Ended up with the lap belt at about 45 degree angle to the drivers hips andthe same width as the drivers hips. Probly added some weight, but feel much better about driver saftey now!! Thanks again.

racer17j
Dirt Forum Champ
Total posts: 5390
posted December 10, 2002 10:01 AM  
We have now welded the new cross bar into the seat frame. If the door bars move the seat will move with them. Thanks again!!

Back to the Archives