Visit The Dirt Forum for More Information

Author Topic:   drive shaft safety
racerwilson
Dirt Freak

Total posts: 357
posted February 08, 2005 11:48 AM  
What is everyone doing for thier drive shaft loops? Are you making your own or going with ones you chassis mfg is making?

bill9j
Dirt Full Roller

Total posts: 35
posted February 08, 2005 04:26 PM  
i was trying to figure out a easy but safe way to do this but its goign to be hard to fit it inside front coverand not have it hitting al the time any ideas

dbradley
Dirt Freak

Total posts: 251
posted February 08, 2005 05:59 PM  
The one we ordered from Bicknell wasn't all that expensive @ $40....When we found out the price we just got it...alot easier i think.
D

bill9j
Dirt Full Roller

Total posts: 35
posted February 09, 2005 03:09 PM  
what did you do just give them the torque arm #,s or is it just a general part

dbradley
Dirt Freak

Total posts: 251
posted February 09, 2005 04:37 PM  
it is a general part....Bicknell has three types...pretty good pictures on the online catalog...BRP1641, 42, 43
D

[This message has been edited by dbradley (edited February 09, 2005).]

Back to the Archives