Visit The Dirt Forum for More Information

Author Topic:   new type caster/camber guage
washeduptoo
Dirt Maniac

Total posts: 185
posted December 24, 2005 09:14 AM  
Anyone tried the new type guage where you don't have to turn your wheels? I saw it on the GRT web site under new items and that is what it stated, but I don't know how much it cost or how it works. I also saw it somewhere else but right now it escapes my memory. Anyone? Thanks for your time.

Mark Wakefeld
Dirt Full Roller

Total posts: 32
posted December 24, 2005 10:02 AM  
It only works on screw on spindles with a keyway to line it up as far as i know, not on stock spindles.


the keyway is what makes it work on aftermarket spindles.

you could do the same thing with a tube and a angle finder between your upper and lower ball joints.

Dman
Dirt Freak

Total posts: 281
posted December 27, 2005 07:51 AM  
The gauge is great. If you read the description it says there are different cutter kits for stock spindles.I have a kit for metrics and pintos. It comes with a cutter you use in a die grinder and a guide nut. Good instructions also. Saves a ton of time and makes weekly maintenance easier. Can you imagine no turn plates? Great product!

Mark Wakefeld
Dirt Full Roller

Total posts: 32
posted December 27, 2005 03:42 PM  
so do you have to remove your cotter pin and nut to screw it on??

I can imagine no turn plates. I use a $2.99 angle finder mounted on a piece of tubing thats notched to fit between my ball joints. just weld a leg off the tubing 90 degrees and set your angle finder on there and read in actual numbers where your at.


Back to the Archives