Visit The Dirt Forum for More Information

Author Topic:   Will a Muncie hold up?
Imracing
Dirt Newbie

Total posts: 2
posted November 23, 2005 07:09 AM  
I have a 4 speed muncie with 2 gears removed. Nickle plated gears inside. I was wondering if it would hold up in a dirt mod. I ran it on pavement and it was great there. Not sure if it will take the pounding on dirt though.

Josh

racer2
Dirt Freak

Total posts: 359
posted November 23, 2005 07:20 AM  
i dont see why not my 3 speed holds up

dirttrackin94
Dirt Forum Racer

Total posts: 92
posted November 23, 2005 07:30 AM  
will hold up fine.i ran the same setup in my late model with a 5.5'' clutch with a 600hp motor for two years and never had a problem with it,i just freshened it up and am now putting it in my modified.

Fastride 38
Dirt Maniac

Total posts: 137
posted November 23, 2005 10:45 AM  
I ran the same muncie for 10 years in a modified. It also had 1st and 2nd taken out of it. It will hold up just fine. The only reason I went to a Brinn is because I sold the muncie.

36modracer
Dirt Maniac

Total posts: 130
posted November 23, 2005 01:38 PM  
I ran the same 3 speed a number of years back for 7 years without doing anything to it. ran it in a street stock a couple yrs then in a mod. then i sold my old mod and the trans to a guy who ran it another 3 seasons before getting a bert.

lfj4
Dirt Newbie

Total posts: 1
posted November 29, 2005 06:53 PM  
they work great we remove firstgear and turn down the out put shaft slightly at the splines so the long yoke on the drive shaft will slide all the way in on a three speed

[This message has been edited by lfj4 (edited November 29, 2005).]

Back to the Archives