Visit The Dirt Forum for More Information

Author Topic:   peirce question??
dirttrackin94
Dirt Forum Racer

Total posts: 80
posted November 16, 2005 06:09 AM  
can anyone help me with a part number for headers that fit a peirce car??also i need the basic setup for a 2000 peirce,4 bar z link setup with pullbar,square tube overslung,short panhard bar off left side.any help greatly appreciated.thanks!

dirttrackin94
Dirt Forum Racer

Total posts: 80
posted November 16, 2005 12:06 PM  
??????????????

shopboss
Dirt Roller

Total posts: 9
posted November 16, 2005 02:26 PM  
give bob a call at the shop 217-354-2972 tell him what you have and he can send you a set up sheet. also if it hasn't had any updates since built new it could use a coulple of things and if you can go to it i would recommend going to bob's seminar in feb. if you're not familiar at all with a pierce car it can help you get it set up right to begin with instead of chasing it all year

spde
Dirt Freak

Total posts: 244
posted November 17, 2005 01:38 PM  
Schoenfeild makes a set. You can get them through me or Bob or them. Equal length primary, nice headers. Dirttrackin give me a # to fax the info to or call me 573-480-5980. thanks ltr

dirttrackin94
Dirt Forum Racer

Total posts: 80
posted November 17, 2005 02:26 PM  
pm sent.thanks alot

WPP
Dirt Freak

Total posts: 454
posted November 17, 2005 06:54 PM  
I have 747 custum kraft on my pierce and i also think 1186 1176 schoenfeld headers work too

wareagle87
Dirt Roller

Total posts: 8
posted November 18, 2005 06:23 AM  
I have the 1176 header. I think Bob even has this number on his webpage.

Have another question. What are the exact measurements for Pierce's rear-end? Anyone know the axle lengths?

dirttrackin94
Dirt Forum Racer

Total posts: 80
posted November 18, 2005 06:49 AM  
i would have to measure my axles,but i do know he uses a 60'' housing with 2'' offset...i had the wrong rearend in my car at one time and had to switch it to this one thus being the reason i know.

48modracer
Dirt Roller

Total posts: 13
posted November 18, 2005 11:42 AM  
quote:
Originally posted by wareagle87:
I have the 1176 header. I think Bob even has this number on his webpage.

Have another question. What are the exact measurements for Pierce's rear-end? Anyone know the axle lengths?


26 1/2 left and 34 on the right

Kenny9K
Dirt Roller

Total posts: 13
posted November 20, 2005 12:12 PM  
Does anybody know the offset on the midplate and to what side?

dirtmod0
Dirt Maniac

Total posts: 145
posted November 20, 2005 02:48 PM  
5/8 to the left.

Back to the Archives