Visit The Dirt Forum for More Information

Author Topic:   Role center
CRC
Dirt Newbie

Total posts: 2
posted August 12, 2005 08:12 AM  
Looking for computer program for setting role center on a metric stub modified

wfoondirt
Dirt Forum Champ
Total posts: 505
posted August 12, 2005 08:56 AM  
http://www.mitchellsoftware.com/

madnik18
Dirt Full Roller

Total posts: 40
posted August 12, 2005 09:56 AM  
http://www.ece.utexas.edu/~santoluc/?N=A

this one is 20$... its good but the camber change is hard to understand... other then that its easy to use...

WRC
Dirt Roller

Total posts: 5
posted August 12, 2005 11:21 AM  
www.auto-ware.com

They have a very good 3D program that allows you to check roll center, camber gain, scrub, bump steer, and gives you sugestions on how to fix it.

Also you need a 3D front geometry program to do anything that does not have the control arms running parallel to the chassis. A 2D program is only good for fabercated chassis that have the suspension pivot parallel to the chassis center line.

I have both and there is a big difference between the too on the same chassis.

There is also www.performancetrends.com that has both 2D and 3D programs.

WRC

[This message has been edited by WRC (edited August 12, 2005).]

Back to the Archives