Visit The Dirt Forum for More Information

Author Topic:   Big Metric Spindle?
Kromulous
Dirt Forum Champ
Total posts: 796
posted April 16, 2005 10:42 AM  
Could someone tell me the measurement on a Big Metric spindle, from the top ball joint hole surface, to the bottom? Basicly how high or tall it is.

Trying to do some roll center work, and considering putting these on our Ford clip. Hopefully they are taller than the factory Ford ones.

sixwillwin
Dirt Freak

Total posts: 493
posted April 16, 2005 02:36 PM  
6 1/2" from the top of the bottoms and the bottom of the tops(basically the inside measurement)

------------------
The Joy of Six website

CUSTOMPERFORMANCE
Dirt Forum Champ
Total posts: 1172
posted April 16, 2005 02:37 PM  
8 3/4 FROM TOP OF SPINDLES TO BOTTOM OF SPINDLE.

CUSTOMPERFORMANCE
Dirt Forum Champ
Total posts: 1172
posted April 16, 2005 02:38 PM  
Where the spindles pin is located between is higher than where a ford is and will lower car and then raise car back up to get more lower control arm travel between frame. This is popular with the ford frame.

Kromulous
Dirt Forum Champ
Total posts: 796
posted April 17, 2005 08:59 AM  
Thanks Custom, exactley what i want to do.

Back to the Archives