Visit The Dirt Forum for More Information

Author Topic:   2-link Setup advice
iowadsmtuner
Dirt Roller

Total posts: 5
posted March 11, 2005 10:08 PM  
I see a lot of 4 link, Z-link and even 3-Link setup information on here but at our tracks b-mods are required to run 2 link setups. Anyone have any advice for running 1/2 mile high banked track and 3/8 low banked track. Just some general info would help. I.e...What different size springs do, what different stiffness shocks do, what caster/camber is good to run. Anything like that would be greatly appreciated. Thanks.

CUSTOMPERFORMANCE
Dirt Forum Champ
Total posts: 1172
posted March 12, 2005 12:10 AM  
3 link is pretty much the same as a 2 link. 2 lower bars with a third on top of rearend for torque control.

racer17j
Dirt Forum Champ
Total posts: 5390
posted March 12, 2005 06:21 AM  
We run old school lol. 91 modified chassis. Running at Fort Dodge, Britt, Fairmont, Mason City and Algona.

Xtreme12x
Dirt Forum Champ
Total posts: 874
posted March 12, 2005 04:13 PM  
come on over to webster... good track to learn on and lots of top notch guys.

With no other knowledge of the car

scale it with about 90 pounds of left rear bite, 49 cross, 53 left, and 57 rear

run 2" offset's on all three corners and then a 3" offset on the right rear

Run a long panhard to start behind the rearend, with about 5 inches of rake down low.

This should get you in the ball park, you'll want a 5.43 or a 5.67 for the half miles and a 6.0 for britt maybe more...

speedy46
Dirt Maniac

Total posts: 165
posted March 12, 2005 06:28 PM  
5.83 for britt to turn 7200 in b-mods

racer17j
Dirt Forum Champ
Total posts: 5390
posted March 12, 2005 08:26 PM  
well good luck i'll be see'n ya in dodge i'm gonna run econo one more year got an old beater to start the year with till i get my new car done i'll be the red and white 17j till i get the new one done it will be blue and white. if your gonna run dodge weekly might not be a bad idea to run webster instead of algona then you wouldn't have to change gears at all

Back to the Archives