Visit The Dirt Forum for More Information

Author Topic:   KSE QUESTION
dirtslinger66
Dirt Maniac

Total posts: 200
posted February 19, 2005 09:13 PM  
I just put a seal kit in my KSE tandem pump and if I tighten the bolts the pump won't spin. If I just snug them it spins just fine. Am I just over tightening it or is there something not right inside?

awkwardjeff
Dirt Forum Champ
Total posts: 562
posted February 21, 2005 09:39 AM  
sounds like the one of the seals isn't seated completely..... also, when you had it apart did you put in a new bushing?? If you replaced the bushing I would say that isn't PERFECTLY square.....

dirtbuster
Dirt Forum Champ
Total posts: 2007
posted February 21, 2005 10:38 AM  
WEnt through this exact thing a few years ago. I eventually sent it in to KSE and what they told me was that one of the intermediate blocks either had a burr or wasnt seating squarely or something, doesnt take much to bind it up. He told me I prob could have fixed it by taking the blocks on a perfectly flat stone, with some 600 wetdry paper and wd40 and make a figure 8 pattern to polish them a little. In the ned it cost me 150$ I think to have it inspected, rebuilt and tested by KSE.

[This message has been edited by dirtbuster (edited February 21, 2005).]

Back to the Archives