Visit The Dirt Forum for More Information

Author Topic:   hanging a body
Dirt Roller

Total posts: 18
posted January 20, 2005 09:39 PM  
I am building a wissota super stock, its close to a mod but full fenders, anyone give a ballpark idea on putting the body mounts on, it is my first time, any help would be greatly appreciated

Dirt Forum Champ
Total posts: 562
posted January 20, 2005 11:27 PM  
At the front of the foot box weld on a piece of 3/4" square tube, weld that on top the tube going forward to the front horns. Weld another piece across on the right tube going forward. Use these tabs you just welded on to BOLT aluminum angle too...... then go the the back of the chassis and weld on 3/4 square tube back there......keep it square. the rear should be 2 inch taller then front.

After you have those to points located pull a string from front to rear........where the string passes the rear hoop is where the center brace should go....... I just weld two tabs on the back of the rear hoop and give them a little twist to get the deck level while the cage is laid back......

Is that what you were looking for??

Back to the Archives