posted January 11, 2005 08:38 AM
anybody using the swivler jack bolt from AFCO. IF so how well are they holding up. Hav ehard some people say they will wear out and get sloppy. Also are you using them on bothe ends of the spring or just one?
Xtreme12x Dirt Forum Champ
Total posts: 874
posted January 11, 2005 11:27 AM
It is ok, but it will send the spring awkward ways as in bow it since it will go towards the side that has the most pressure. What works better is taking your standard weight jack and using a bold with a little slack in it.
dirtbuster Dirt Forum Champ
Total posts: 2007
posted January 11, 2005 11:51 AM
i thought maybe it would get awkward with it at both ends.
Right now we have spring cups that fit loose on top of the bolt. maybe those are better anyway. gives it some room to move but limits total travel.
zeroracing Dirt Forum Champ
Total posts: 1875
posted January 11, 2005 12:30 PM
www.bsb-mfg.com they make a nice new spring cup that swivels, it clamps to the axle tube. you may have to call them to get more info, it is in thier cataloge.
showtime13 Dirt Full Roller
Total posts: 60
posted January 15, 2005 07:17 AM
We use them on the front and I like them real well.....I think they freed up the car a good bit. You dont here any coil bind when you bounce the car up and down or when you are just jacking the car up off the floor.