Visit The Dirt Forum for More Information

Author Topic:   Roll Center File
dogwalker
Dirt Full Roller

Total posts: 65
posted October 15, 2004 08:24 AM  
Does anyone have the roll center file that was in the toolbox before it was removed. I think the name of the file is rollcenterinstaller.exe or something similar. Anyways, just want to verify that the all the control arms and ball joints are in the right place.

jammin
Dirt Administrator

Total posts: 6243
posted October 15, 2004 08:28 AM  
Who is Sal and how can we contact em? Sounds like an easier way than drawing it out on a sheet of plywood. What is everyone else using? Ive seen a few articles in Circle Track regarding setup software, but just want to simply look at front end geometry/roll center. Most software has a lot of other stuff I don't need. Was hoping someone had the one file that was in the toolbox when it was still "freeware/shareware" they could email.

[This message has been edited by dogwalker (edited October 15, 2004).]

Rook78
Dirt Maniac

Total posts: 106
posted October 15, 2004 09:00 AM  
I still had it in my history as I tried getting on a few days ago. Here ya go.
http://www.exe.utexas.edu/~santoluc/Roll%20Center%20Plus%20Installer.exe


dogwalker
Dirt Full Roller

Total posts: 65
posted October 15, 2004 09:38 AM  
That's the file, but it has been taken off of that web address for download. Someone would probably need to have the file itself.

Back to the Archives