Visit The Dirt Forum for More Information

Author Topic:   pull bar mounting location
chapa73
Dirt Maniac

Total posts: 169
posted September 07, 2004 03:05 PM  
Im getting ready to mount a monte bar in my modified.
I know its been explained but really couldnt find what I needed.

Were does it need to mount in the chassis.in line with drive shaft or is there some other way?
I seen something about left side % of the rear track width.
My next question is, Is track width how much tire is contacting the ground? How do you figure track width?

Thanks

dirtywrench13
Dirt Freak

Total posts: 324
posted September 07, 2004 03:26 PM  
MOST LONG PULL BARS MOUNT JUST BEHIND THE SLIP YOLK JUST BEHIND THE TRANS.SOME ARE JUST A FEW INCHES ABOVE THE DRIVESHAFT.
ONE PERSON ON THIS FORUM STATED HIS IS HIGH ENOUGH THAT HIS IS FLAT WHEN AT RIDE HEIGHT.
OUR D-W 8 IS SOLID ON THE CHASSIS BEHIND THE TRANSMISSION, AT A 28* ANGLE.
I'M GOING TO CHANGE IT FOR NEXT YEAR, I JUST MADE MY MIND UP WHERE IT WILL BE YET.

Back to the Archives