Visit The Dirt Forum for More Information

Author Topic:   Brinn seal and bushing?
norightturn
Dirt Maniac

Total posts: 159
posted July 09, 2004 06:50 AM  
Does anyone have info or part numbers on the rear seal and bushing for a brinn transmission?

jws
Dirt Maniac

Total posts: 115
posted July 09, 2004 07:21 AM  
Just changed mine last night. I don't have the #, but it should be available through any Brinn dealer. It was about $14 for both. I know that the seal is just a powerglide or T-350 seal and I think that the bushing may be the same. By the way the bushing is not a real quick job. You have to remove the tail housing and then you need a good snap ring pliers to be able to remove the shaft assembly from that tail housing. Then you have to get the dog rings lined back up when you reassemble, which requires pulling the side cover with the shift forks. I had mine apart for clutches so I had to tear it all the way down.

NJantz
Dirt Forum Champ
Total posts: 755
posted July 09, 2004 11:32 AM  
I run the same rear seal in my Falcon as I did my power glide. I'd imagine the brinn uses the gm trans seal. It is NAPA 1-4557.

Dman
Dirt Freak

Total posts: 270
posted July 09, 2004 12:50 PM  
They make a tool for pulling the tailshaft bushing out without taking the tailshaft housing off, and another tool for re-installing the bushing.Saves alot of time and hassle.Most all trans. shops have them.
Dman

SUPERDIRT
Dirt Roller

Total posts: 5
posted July 09, 2004 04:25 PM  
power glide bushing and seal works

hamer36
Dirt Maniac

Total posts: 196
posted July 11, 2004 10:38 AM  
Also same as turbo 350

rcndirt
Dirt Full Roller

Total posts: 27
posted July 11, 2004 12:08 PM  
We get ours from Day Motorsports. they have the full Brinn Breakdown in their catalogue. they have a good website as well.
http://www.daymotorsports.com/

hamer36
Dirt Maniac

Total posts: 196
posted July 11, 2004 04:48 PM  
Dman
Can you get me a part number or supplier on this bushing tool? Thanks

Back to the Archives