Visit The Dirt Forum for More Information

Author Topic:   rcf mods
Dirt Forum Champ
Total posts: 1875
posted May 13, 2004 05:55 AM  
i just got a 97 rcf mod as a backup and my dads toy. its a bare frame. does anybody out there have one? what upper a arms are used they look like the dw corrected front end ones, but was not sure about tube length? anybody out there have an rcf, and found any problems?

Dirt Full Roller

Total posts: 54
posted May 13, 2004 06:51 AM  
I run a RCF chassis but it had the ajustable control arms with the set screws. We change it over to the dirtworks style with Nova lowers and pinto spindles. I can check to see the lengths we have on it now. Mine is a metric though my friends RCF is a Chevelle 73' and up I can check his length if you let me know what frame you got. There a good car they take a lot of abuse. Both of ours are a little left side heavy but it works good at our track.

Dirt Forum Champ
Total posts: 1875
posted May 13, 2004 08:45 AM  
it is supposed to be an old chevelle like a dirtworks car with pinto spindles.
how can i tell the difference with no parts on it? what measure ments will tell me what it is for sure?
everything else i have is metric so i am not super familiar with the front ends on chevelles.

Dirt Forum Racer

Total posts: 87
posted May 13, 2004 10:24 AM  
It is easiest to tell by looking at the sides of the frame rails. The chevelle's are flat on the sides, and the metric style have a strengthening ridge all the way along (at least I guess that's what it is).

Back to the Archives