Visit The Dirt Forum for More Information

Author Topic:   harris mod question
dirtbandit
Dirt Maniac

Total posts: 110
posted April 19, 2004 12:26 PM  
Putting together my first mod, its a 98 harris and am putting on an afco pull bar but i dont find a mount for it??? I was told that they run a long bar and the only thing close i can find are the holes drilled in the driveshaft hoop. Is the the correct place to mount it???
Thanks for the advice

dirtbuster
Dirt Forum Champ
Total posts: 2007
posted April 19, 2004 12:40 PM  
yep that would be the place...

dirtbandit
Dirt Maniac

Total posts: 110
posted April 19, 2004 02:11 PM  
Also, what do you use to keep the pull bar from moving side to side? Cut a sleeve to go over the bolt?


wdf
Dirt Roller

Total posts: 10
posted April 19, 2004 02:28 PM  
harris makes a real neat adjuster bolt. call them and get one.

dirtbuster
Dirt Forum Champ
Total posts: 2007
posted April 19, 2004 03:11 PM  
You can use buching stock to make spacers or you can use the adjustable bolt like mentioned above. Either way check to make sure you have driveshaft clearance. Our DW car has 2 sets of holes and in the bottom set it just barely clears the driveshaft.

49mtmod
Dirt Maniac

Total posts: 127
posted April 19, 2004 07:12 PM  
Get the Harris set up. By removing the nut and tightening or loosening the bolt you can move the torque link left and right which you can't do with spacers.


Wildside17
Dirt Maniac

Total posts: 119
posted April 19, 2004 09:13 PM  
Call Reese or Jay at Harris and tell them you want the torque link quick adjuster kit it's 30 or 31 dollars. They can answer any other questions you may have.
800-833-5174

fastow
Dirt Maniac

Total posts: 168
posted April 19, 2004 11:27 PM  
Dirtbuster you use the bottom or top hole to mount the front of the pull bar to the driveshaft loop?

Back to the Archives