Visit The Dirt Forum for More Information

Author Topic:   DEGREEING 2300 CAM
TBROOKS
Dirt Roller

Total posts: 16
posted November 29, 2005 06:09 PM  
CAN SOMEONE TELL ME THE BEST WAY TO DEGREE A 2300 FORD CAM? ITS A RACE ENGENEERING .528/.538 LIFT 254 @.050 SOLID LIFT.

BCR2005
Dirt Newbie

Total posts: 1
posted December 01, 2005 03:54 PM  
Get your a degree wheel set per cam card!

juliaferrell
Dirt Freak

Total posts: 382
posted December 02, 2005 08:25 AM  
go to one of the cams websites....technical information....and view the procedure. Cam in a 2300 is no different than anyother. Easiest way is intake lobe centerline method *remember to set to 0 lash. I believe that cam sets at 103 or 104 After Top Dead Center. The E bar method Essy uses won't work on that cam..It will be close but not on.

Back to the Archives