posted September 05, 2004 12:57 PM
Built new head,installed new cam and followers,installed head,fired up in shop.ran for 10 min.and noticed valve train noise.removed valve cover and noticed followers severly worn on the adjuster side of follower?valve side shows no wear what so ever? what gives guys?
bigcityracer Dirt Freak
Total posts: 431
posted September 05, 2004 08:13 PM
When breaking in a new cam you should use lighter valve springs to break in the swap them for the correct springs. Your center of the rocker pad should be centered on the cam travel.
racerman707 Dirt Freak
Total posts: 374
posted September 07, 2004 01:04 PM
Who set the geometry?
way2fast72 Dirt Freak
Total posts: 303
posted September 07, 2004 02:21 PM
got it figured out guys thanks for replys.