Visit The Dirt Forum for More Information

Author Topic:   DRY SLICK SET UP
LMDIRTFAN_42
Dirt Roller

Total posts: 7
posted December 21, 2003 10:26 PM  
I NEED INFO ON DRY SLICK SET UP FOR A 02' IRONING BOARD RAYBURN

mccoy2m
Dirt Newbie

Total posts: 1
posted January 10, 2004 12:42 PM  
springs lf 500 fr 450 lr 300 rr 200 shocks 74lf 75 rf 94 lr 94 rr ride heights should be lf 2.25" rf 2.375" rr 4.25" top of rear to bottom of cage set wedge in car on lr 4 bar should be l bottom middle hole l top 2nd hole from top r bottom middle hole r top top hole torque arm 300# spring at middle setting 6th coil set pinion at 6 degrees panhard bar long j bar high on frame side 1.5" up from bottom to start tire press shouldc be lf 8 lr 6 rf 10 rr 10

Greggie
Dirt Freak

Total posts: 298
posted January 27, 2004 09:00 AM  
I'm just new to this late model stuff.... What is an "Ironing Board Rayburn"?

Greg

fr1
Dirt Forum Racer

Total posts: 93
posted January 27, 2004 06:42 PM  
Greg I'm not new to Rayburns, but I've never heard that terminology either. C.J. doesn't run a Torque arm either. They all have pull rods when they leave his shop.

GO 24
Dirt Freak

Total posts: 366
posted January 28, 2004 11:23 AM  
If I'm not mistaken you can order them either way and I know quite a few guys who like the torque arm more so they just switch them over---not to uncommon. Mine had one but a friends of mine had the pull bar---go figure.

Back to the Archives