Visit The Dirt Forum for More Information

Author Topic:   tight on entry
rjp
Dirt Roller

Total posts: 24
posted February 24, 2000 12:24 PM  
Have a 97 GRT which is setup to run coil over behind LR, lower frame rail has been lowered. Can any one tell me the best way to combat a corner entry push?
setup: LF-500 RF-450
LR-275 RR-225
short panhard on leftside of pinion
53% left 54.5% rear without driver

track is semi banked, sweeping corners, doesn't take alot of rubber on corner entries

Any suggestions will be greatly appreciated

jammin
Dirt Administrator

Total posts: 6243
posted February 24, 2000 12:29 PM  
yes, one 90/10, 5th coil is 300lb

rjp
Dirt Roller

Total posts: 24
posted February 24, 2000 01:34 PM  
yes, 1 - 90/10, 5th coil is 300lb located at I think 36 inches

rjp
Dirt Roller

Total posts: 24
posted February 24, 2000 01:59 PM  
forgot to mention 76 shocks on front
94/6 LR and 94 right rear.

HRS
Dirt Administrator

Total posts: 14
posted February 25, 2000 06:45 AM  
RJP--

I am assuming your LR is 4 on compression and 6 on rebound. If this is true, take that thing off and switch over to a straight 94 or 93. (93 is better for weight transfer coming out of the turn if you can get by without wheel hop.) The split valve shock on the LR is not allowing you to turn in.

Good luck this year!

racer
Dirt Newbie

Total posts: 1
posted March 01, 2000 07:43 PM  
clamp rear brakes to tubes

jammin
Dirt Administrator

Total posts: 6243
posted March 06, 2000 08:11 AM  
You can increase crossweight also, this will take a little RR bite out of the car.

Back to the Archives