Visit The Dirt Forum for More Information

Author Topic:   screw in stud question
demonseed
Dirt Newbie

Total posts: 4
posted September 08, 2005 09:39 PM  

I have a good set of heads(441) which have screw in studs and guide plates but our rules do not allow screw in studs and guide plates and i was wondering if there is a way to take out the guide plates and install a shim or washer to take up the space of the GP. and also is ther anything i can do to disguise the look of the stud so that it would look like a pressed in stud... thanx....

ryan
Dirt Forum Champ
Total posts: 776
posted September 08, 2005 11:13 PM  
They make stock appearing screw in studs pretty much the same as what you've got with out the shoulder.

avila
Dirt Freak

Total posts: 217
posted September 09, 2005 11:14 AM  
I used thoses stock appearing screw in type studs
for years and always passed tech.

James Ott
Dirt Maniac

Total posts: 131
posted September 09, 2005 06:59 PM  
Ok... now who is they?

track_trash_66
Dirt Full Roller

Total posts: 50
posted September 09, 2005 07:30 PM  
http://www.speedwaymotors.com/xq/aspx/paging.yes/dept_id.129/display_id.838/qx/Product.htm

ryan
Dirt Forum Champ
Total posts: 776
posted September 09, 2005 07:36 PM  
THEY are dang near every catalog that has screw in studs.

sideways
Dirt Forum Champ
Total posts: 715
posted September 09, 2005 08:34 PM  
I have found that a proper fitting lock washer is about the same thickness as a plate.

ruggs66
Dirt Maniac

Total posts: 193
posted September 09, 2005 09:29 PM  
Remember, the head will be cut down where the stud goes and the other studs might not be at the right length when installed.

DJR22
Dirt Maniac

Total posts: 111
posted September 09, 2005 11:52 PM  
Do they actually tech to see if you have screw in's?!? I wouldn't worry about it. Run what you got til you get cought. If they actually said something, just make up an excuse, like you bought the motor that way and never lifted the valve cover. lol. I know that theres so much power lying in those guide plates and screw in studs!

------------------
-stand on it-

Back to the Archives