Visit The Dirt Forum for More Information

Author Topic:   6:00" rods in SBC
bubbalouie
Dirt Newbie

Total posts: 4
posted April 19, 2005 09:10 AM  
Anyone know about the durability of a 350C w/ 400 crank and 6" rods and offset pin height to allow the long rods on the track. I know guys that are runnig that combo on staright tracks, but they only run 'em for 9 to 11 seconds at a time.

Looking for some input on 20 - 40 lap features.
Thanx

dirtbuster
Dirt Forum Champ
Total posts: 2007
posted April 19, 2005 09:25 AM  
that would be your typical 383 combo. Lots of guys running them and no problems with them if they are built right, just like any other combo.

zeroracing
Dirt Forum Champ
Total posts: 1876
posted April 19, 2005 08:37 PM  
Some sbc motors get as long as 6.350 or slightly longer rods. This is on short stroke motors, and VERY short pin height.

dirtracer14
Dirt Forum Champ
Total posts: 1261
posted April 19, 2005 09:24 PM  
I have a 6" 383 that i use for a backup motor...pulls hard. The pins are up in the bottom ring lands.

Back to the Archives