Visit The Dirt Forum for More Information

Author Topic:   push rods...?
goinrcn44h
Dirt Freak

Total posts: 205
posted April 12, 2005 07:34 AM  
I am lookin for some hardened good 7.5" pushrods. I am havin to use offset lifters and the crowers are like .5 taller than the regular crowers. the offsets are the cutaway style so no rev-kit either but that doesnt concern me . I just need the short push rod or where to get them. any ideas?
44H

stockcar5
Dirt Forum Champ
Total posts: 578
posted April 12, 2005 03:33 PM  
competition products has some nice pushrods you can get in any custon length. $129 for 5/16th and $139 for 3/8th.

------------------
www.geocities.com/dirtstockcar5

goinrcn44h
Dirt Freak

Total posts: 205
posted April 12, 2005 06:21 PM  
Well,
A chevy LS-1 I guess says it uses a 7.4" pushrod on 97-00 engines.. call me ignorant but what has a LS-1 in it , etc...?
if I don't find any and soon I will just get a set comin from crower, they are in california so it would be like 2 days regular ground...
I have no clue where comp products is ...? I just can't believe this isn't a bigger issue, I mean alot of people run the cutaway style I would assume.. oh well...
44H

dirtracer14
Dirt Forum Champ
Total posts: 1261
posted April 12, 2005 08:42 PM  
Those rockers work out for ya?? I might have the pushrods you need.... ill check!

dirtracer14
Dirt Forum Champ
Total posts: 1261
posted April 12, 2005 08:56 PM  
One set is 7 3/4 and the other is 7 7/8 i dont think they are complete sets thow.

Back to the Archives