Visit The Dirt Forum for More Information

Author Topic:   Angle mill heads
Bandit1716
Dirt Roller

Total posts: 5
posted December 25, 2004 06:12 PM  
I have several double hump heads. We are required to race them,or any iron heads.I want to angle mill them.Can anybody give me how much to take off. I am running alki,with dome pistons. Thanks

ctfarm
Dirt Freak

Total posts: 206
posted December 25, 2004 07:46 PM  
The last set we had done was cut 0.175.This doesn't leave room for any more surfacing.Most shops cut 0.150.If there done right,the intake will fit correctly.


engineman
Dirt Full Roller

Total posts: 55
posted December 26, 2004 04:56 AM  
I've done .185 off of virgin heads, but like he said, there aint much room for "cleanin up the surface"!
If youre "scared" just cut em .150, but if you want everything you can get, go .175...and never look back!

------------------
Mark's Racing Engines

(903)883-0196

www.northtexasracing.com

engineman@northtexasracing.com

Sidebite252
Dirt Forum Racer

Total posts: 98
posted January 02, 2005 06:33 PM  
A couple of point to ponder.....
Re-face the held bold head surface on the head itself to the same angle of the new head or your head bolts will not seat correctly in the head (uneven surface.) We also had a header clearance issue with the new angle - head clearance over the frame dropped. You will need to re-face the intake surface of the head. The most we have milled double humps are .100 to .125.

Bandit1716
Dirt Roller

Total posts: 5
posted January 06, 2005 06:04 PM  
Thanks great info.Larry

Back to the Archives