posted December 08, 2004 07:40 PM
Working on building a backup motor for next year and thought I would put some roller cam bearing in (new for me). They arrived today and I have noticed that there is no hole for oiling in the bearings. What's up with that? Do I need to tap some squinters in to oil these cam bearing?
TRNLFT25 Dirt Roller
Total posts: 19
posted December 08, 2004 09:08 PM
no oilers needed.they get enough from valley drain holes and splash.although if you are wanting to use a stock block after you bore the cam bearing holes to the larger size you may experience breakage between the cam and main webs.
[This message has been edited by TRNLFT25 (edited December 08, 2004).]