Visit The Dirt Forum for More Information

Author Topic:   Solid Pull Bar
Fast132
Dirt Roller

Total posts: 21
posted October 11, 2002 10:12 PM
We are going to try a solid pull bar this week after reading on here about them. We have a 3 link, RR behind, LR in front, with a J-Bar. The car has been very fast but there's one guy who's very tough to beat.
We are switching from a coleman style springrod with (I believe) a 650lb spring. I solid bar the same as our spring bar, about 17* down, it's 18" long. It's also towards the right rear 1/2 way from center.
Any last minute suggestions or theories that might help? Can you tell me what I might expect? The track is a paper clip 3/8.
Thanks,
Fast132

Fast132
Dirt Roller

Total posts: 21
posted October 13, 2002 01:57 PM
Hated it. Car would not hook at all, Very loose in, and instant loose on the gas unless car was absolutely straight. Could have put an egg under my right foot and still would not go forward well. The track never was heavy though, threats of rain meant it was watered late and little, so by the heatit was already dry/slick.
We put the spring bar back on for the feature for a huge improvement. Did we do something wrong, or is it just my chassis didn't like it?
Fast132

24mod
Dirt Roller

Total posts: 6
posted October 14, 2002 11:40 AM
Try mounting it offset to the left of center on the rear end. That will help influence the left rear more and create forward bite. Try some more angle as well, I run about 25 degrees. If the track isnt ruff of tacky, through that J-Bar away and go to a short bar on the left of pinion.

2nd2none
Dirt Maniac

Total posts: 195
posted October 14, 2002 12:42 PM
check your pm's fast132

2nd2none
Dirt Maniac

Total posts: 195
posted October 15, 2002 04:43 PM
how much pinion angle did you have in it?

Back to the Archives