Visit The Dirt Forum for More Information

Author Topic:   Need help gettting through corners
redbirdtiger
Dirt Newbie

Total posts: 3
posted May 28, 2002 12:48 PM
We seem to have enough hp, and have the gear ratio right. However, we seem to push going in and are loose coming out. We've tried a few things, but can't seem to get faster in the corners. I hold my own, but can't seem to get around the big boys. We run a limited latemodel, basically a modified chassis. Any suggestions would be appreciated. Thanks!

Modracer05
Dirt Forum Racer

Total posts: 85
posted May 28, 2002 02:20 PM
There are alot of things that can cause that condition.
Without much info on the chassis and setting I would suggest a little more LR bite. This should loosen the car on entry and tighten it on exit.

2nd2none
Dirt Maniac

Total posts: 193
posted May 28, 2002 07:48 PM
a little more rear percent might do the job, but without any of your chassis setup info its hard to give a good answer. I noticed this was your first post, this forum has alot of guys that are smart and will help you out, dont be shy on giving out your spring rates and shocks, etc.

[This message has been edited by 2nd2none (edited May 28, 2002).]

redbirdtiger
Dirt Newbie

Total posts: 3
posted May 29, 2002 09:27 AM
I'm going to the shop tonight, I'll get the latest chassis setup. Thanks!

PEDDLER
Dirt Freak

Total posts: 227
posted June 02, 2002 08:58 PM
Fix the push going in and the loose condition will repair itself.

Back to the Archives