Visit The Dirt Forum for More Information

Author Topic:   tight in center
Dirt Newbie

Total posts: 3
posted May 06, 2002 07:50 PM
I am new to modifieds. so any suggestions would be appreciated. I have a 3-link suspension with the springs on top of the rear end. The pannard bar is attached to the frame on the left side, and in the top hole on the pinion. I am running 750lf 850rf 175lr 175rr springs. with about 80# of left rear. The trailing arms are up hill at 5 degrees. Thanks for any replies

Dirt Maniac

Total posts: 193
posted May 06, 2002 08:14 PM
put panhard bar 2nd to bottom hole on pinion side and about 9" up on chassis side, put 200# spring on LR and remove about 30# of LR bite.

Dirt Newbie

Total posts: 3
posted May 06, 2002 08:24 PM
thanks for the reply. About how much rake do you run in you pannard bar when you run it down that low.

Dirt Freak

Total posts: 242
posted May 07, 2002 01:53 PM
TIght in the center only? If so try adding stagger first.

Dirt Roller

Total posts: 16
posted May 07, 2002 03:54 PM
try to swap frt. springs just remember to reset the cross %

Back to the Archives