Visit The Dirt Forum for More Information

Author Topic:   clutch master cylinder size
Dirt Maniac

Total posts: 167
posted July 09, 2002 06:53 PM
I was wondering what size of a bore I should use in my master cylinder for my clutch. Right now I have a 1 inch, should I drop down to a 3/4 inch? I'm using a wilwood pull-type slave cylinder. Thanks for your help.


Dirt Maniac

Total posts: 111
posted July 10, 2002 12:43 PM
HI justin. If you drop down to a 3/4 bore master cylinder this will make the pedal a little easier to press but it will also make the travel a bit longer. If you are after reducing brake effort then you should take a look at the pedal ratio or just lengthen the pedal. The master cylinder you have sounds ok to me for a single cylinder set up though.
Cheers. marty.

Back to the Archives