Visit The Dirt Forum for More Information

Author Topic:   Offset Cross Shaft
RangeRover
Dirt Maniac

Total posts: 174
posted June 27, 2002 07:50 AM
I've heard that there are cross shafts for the upper A arms with a built in offset. That would help get the the correct camber much easier, specially the LF. I've heard or read that Moog makes it, but I didn't see it in Speedway, Afco, or Summit catalogs. Any ideas?

J-Dub
Dirt Roller

Total posts: 5
posted June 27, 2002 11:40 AM
I purchased one for my metric car last year at Advance Auto Parts. I don't remember if they had to look it up in the book or not, but they did get it PDQ(1-2 days) from the warehouse.

From www.advanceautoparts.com:

MCQUAY NORRIS FA1391 $41.99
CONTROL ARM SHAFT ASSEMBLY: Front; Upper; Offset Shaft Kit Provides Additional Positive Camber Adjustment

[This message has been edited by J-Dub (edited June 27, 2002).]

49mtmod
Dirt Full Roller

Total posts: 56
posted June 27, 2002 03:28 PM
I used these on the LF of my metric and it did help me get better camber settings. However, I found them to be very weak. I bent a couple of them with some pretty light contact.


YAZ
Dirt Forum Racer

Total posts: 77
posted June 28, 2002 07:16 AM
AROUND HERE NAPA, AUTO VALUE, CAR QUEST
ALL SELL IT.I WAS GOING TO PUT ONE IN,
BUT MY RULES WOULDN'T ALLOW THEM, SO I
TOOK THE GRINDER TO MY STOCK ONE AND
JUST TOOK ENOUGH OFF TO GET THE CASTER/
CAMBER I WANTED.

Back to the Archives