Visit The Dirt Forum for More Information

High Velocity Sports
Dirt Roller

Total posts: 5
posted June 06, 2002 11:46 AM
STEERING WHEEL RECOMMENDATIONS-SIZE? OFFSET? My rules state I must use a stock column for the 1979 Camaro I am building. What is a good size wheel? What offset should I get? How about quick connect hubs for a stock column. Thanks guys! Race on!

Dirt Freak

Total posts: 295
posted June 06, 2002 11:49 AM
i race a '79 firebird and use the stock column with the stock wheel.

redneck bubbas racing
Dirt Freak

Total posts: 213
posted June 06, 2002 08:01 PM
The adapters will fit your stock column. You nned to grind or cut off the threaded part and then set the adapter on and weld. Make sure that it will go on first though, I don't want you cussing me about it! Mine fit right where the smooth area was and slid right down, nice and secure.

Dirt Forum Champ
Total posts: 1565
posted June 07, 2002 01:46 AM UIN: 54865418
mine is set up like rednecks but i didn't do anything more than took the wheel off i found out the hard way that if you gut to much out and get the weld to close to the bushing it will melt it and after haveing to buy a new hub and fitting i just put in on the threaded part and welded it real good on the inside of the hole with a stick welder and mig welded the other end as for a wheel most guys will use any 15 in wheel you see in all the mags a few will go to a 17 but i don't like it

Back to the Archives