posted June 05, 2002 11:50 PM
what exactly is the proper way to set the floats and idle mixture (i.e rich/lean) settings on a 650 double pumper carb?
mansfief Dirt Roller
Total posts: 18
posted June 06, 2002 10:22 AM
Contact Earl Parker (www.parkercarburetion.com) He is, I think, in NC.
redneck bubbas racing Dirt Freak
Total posts: 213
posted June 06, 2002 08:07 PM
Earl is the man but I'll through my pennies on the floor too. You want the floats set where the fueljust barely dribbles out of the sight plugs while the motor is running. As far as rich/lean here is my method. Turn the screws in all the way until they SOFTLY bottom out. Back them all out 1 and 1/2 turns. Crank it up and adjust one at a time starting in the front while looking for the highest vaccum reading. After you have done all of them reset your idle and do it again.
The Outlaw Dirt Maniac
Total posts: 159
posted June 07, 2002 01:12 AM
ok thanks redneck, thats how i did it anyway...we will see how it works, had just been a while since i did it was all...thanks guys