Visit The Dirt Forum for More Information

Author Topic:   Metric A-arm swapping
No Shame
Dirt Newbie

Total posts: 4
posted December 10, 2001 12:28 AM
Im sure you all have discussed this many times on this board, but Im new to this and am asking again. What other GM top a arms carry the same metric pattern for bolting on?
Meaning is there a suitable replacement for the metric a-arm on the left front that will extend that out and prevent the camber loss on travel?
Any help would be cool. Thank you

poboy2
Dirt Freak

Total posts: 219
posted December 10, 2001 08:22 PM
Don't know about upper control arms, but here is an idea. A spindle off of a 78 and up metric Impala uses the same ball joints and is taller. The upper part of the spindle is offset from the bottom more than a standard metric spindle. This should give you more adjustment and offset your roll center to the left.

Back to the Archives