Visit The Dirt Forum for More Information

Author Topic:   Valve train
P5Racing
Dirt Full Roller

Total posts: 41
posted March 17, 2003 02:04 PM
we have bent 8 push rods. rocker arms and push rods were all stock. WE have a 519 to 529 lift cam. we put guide plates on but push rods looked to short. what do i need to do to stop this and make it work.

[This message has been edited by P5Racing (edited March 17, 2003).]

rico 08
Dirt Freak

Total posts: 372
posted March 17, 2003 02:19 PM
Is it a small basecircle cam?If so you will need longer pushrods,you can borrow a checker from a good machine shop,with that much lift you will need long slot rockers at a minimum and should really go with roller rockers IMHO

dirtbuster
Dirt Freak

Total posts: 353
posted March 17, 2003 03:06 PM
What valve springs do yo have? Did you check to make sure they dont coil bind with that lift?

Where are the pushrods bent.. in the middle or towards the end near the rocker?

Back to the Archives