posted January 20, 2003 10:33 PM
witch one is better?
Racer14K Dirt Freak
Total posts: 247
posted January 21, 2003 12:04 AM
spanky43 Dirt Roller
Total posts: 22
posted January 21, 2003 12:40 AM
***** ins and use arp brand for strength. have machine shop mill for ***** ins and guide plates so you will not have any clearance problems
dadwhisky78 Dirt Roller
Total posts: 14
posted January 21, 2003 05:12 PM
I agree spanky. I would use 7/16 studs when I have them installed.
rfb320 Dirt Full Roller
Total posts: 43
posted January 21, 2003 09:45 PM
the extra money you spend on the ***** in studs is well worth it. pining a stud just isn't as good.
30rulz Dirt Roller
Total posts: 24
posted January 21, 2003 10:03 PM
check with crane. they have a tool to mill the heads for ***** in studs and you don't have to take them to a machine shop. just put this little gizmo in your drill and it takes the right amount off and at the right angle and bottoms out when its done. it has a long stem that fits in the stud hole to keep it straight. I saw one in a catalog at a parts store.