Visit The Dirt Forum for More Information

Author Topic:   Steve Hendren
STICK01
Dirt Full Roller

Total posts: 52
posted May 09, 2002 10:45 AM
Steve,

Need help on pricing parts for sale, do not know what engine stuff is worth, just know that I do not want it around anymore. LOL

Set of .030 cast KB pistons and stock rods?

.030 350 block honed, line bored, ready to assemble w/cam bearings installed.

350 cast crank .010/.020

flat-tappet cam and lifters (or just junk it)

Bowtie heads w/2.02 & 1.6 and 1.47 valve springs ported pretty large.

Vortec heads 2.02/1.6 and new valve springs, just completed valve job, never ran on engine. 3/8 studs and no guide plates.

set of roller tip rockers for above Vortec heads w/guides.

Any ideas would be appreciated and all is for sale. Just don't know what to ask money wise.

Stick

HENDRENS RACING ENGINES
Dirt Roller

Total posts: 5
posted May 09, 2002 12:29 PM
Hey ,

If I could see the block , heads , and other parts , then I could give you a good idea of the value . Your best bet would be to go to racersauction.com , and see what these parts are selling for used . Then you will have an accurate idea of what the value is on the parts you listed . I'm sure you will be able to sell everything , or at least action everything off .

Steve

------------------
HENDRENS RACING ENGINES BILL HENDREN

Back to the Archives