Visit The Dirt Forum for More Information

Author Topic:   Camamshafts
chevyscrounger
Dirt Full Roller

Total posts: 43
posted December 08, 2001 02:54 PM
I have a cam card that The measurment are taken at .020 Tappet hieght. How do I convert it so the measurements are at .050 tappet hieght? This is probably simple to do but I'm not too good at math.

bbracer17
Dirt Freak

Total posts: 256
posted December 08, 2001 03:55 PM
I assume you are talking about the duration measurment. I don't beleive there is a magic formula to convert from .020 to .050 because the ramps on the cams can be different. If you have the cam card with the brand just call the cam manufacturer and they can give you every measurement you need.

4barrel
Dirt Full Roller

Total posts: 26
posted December 12, 2001 08:23 PM
does this cam card list a center line on that it was ground on ? if so just use the intake center line meth to install it.go to comp cams web site it will tell you more.

jammin
Dirt Administrator

Total posts: 5556
posted December 13, 2001 12:55 AM UIN: 16262997
Call Charles at Camcraft and tell him The Dirt Forum sent ya.

Charles can tell you anything you need to know and more....man knows his stuff. After you talk to him, you will never buy another over the counter camshaft.
http://www.camcraftcams.com
(800)426-2261

Back to the Archives