Visit The Dirt Forum for More Information

Author Topic:   Engine, Clutch, Sportsman heads for sale
chomme
Dirt Full Roller

Total posts: 52
posted July 26, 2001 06:29 PM UIN: 1986763
Motor for sale. The motor has three nights of racing on it. It's a 383 small block stroker motor. 350 four bolt block, bored .030 and was decked and the main alignment was checked as well. It has a Scat Cast Steel 3.75" stroke crankshaft, GM powdered metal 5.7" rods, TRW 12.5:1 hypereutectic pistons, speed pro moly rings, michigan 77 bearings, crane solid cam/solid lifters. It has a cloyes timing chain, and a 400 balancer and pork chop for the flywheel. The heads are the 292 angle plug castings. The heads were fully ported by Ron's Porting. They have ***** in studs, guideplates, and Crane aluminum roller rockers on them. The oil pump is the Mellings M55HV pump along with the steel drive shaft/sleeve and a Milodon circle track oil pan. It was fully balanced (B.C. Gerolomy Racing) and professionally machined/assembled (Bud Walmer's Machine in Orangevale, CA...they build such motors as Mark Welch (many know him from IMCA). The motor is basically a long block + oil pan, timing cover, balancer/pork chop, crank pulley, and water pump/pulley and fan. It also includes the aluminum circle track valve covers. It does not include intake manifold/carburetion/ignition. For the motor, we are asking $2,500.

I also have a 10,000 RPM triple disk clutch for sale...brand new, in the box. It is the lightweight (11.5 or 12 lbs, I forget...including flywheel, clutch, and all). It also has the 10,000RPM self aligning throwout bearing with it. I would take $725.00 for that (brand new in the box).

I have a brand new, in the box Lakewood blow-proof bellhousing for the SBC that I would sell as well...$190.

Muncie transmission set up for circle track racing. Has first and second removed, a lightweight third, and full fourth gear in it along with reverse. I would take $400 for the transmission (has two races on it).

Also I have a set of Dart Sportsman cylinder heads...64cc, straight plug. Brand new, in the box...bare. I would take $450 for them.

Email me at chad.homme@bigfoot.com if you are interested in anything, or call me at 916-202-1854.

Back to the Archives